NewburyportNews.com, Newburyport, MA

Business

November 12, 2013

Keeping your ducts in line

Yes, that’s “ducts,” not “ducks.” Many homes, particularly newer homes, have forced hot air furnaces that use air ducts to distribute heat and conditioned air throughout the house. Only in very recent years have HVAC installers been made to seal air ducts as a building code requirement. As a result, leaky air ducts abound, and homeowners are paying for it. Besides the cost and waste of your heated or conditioned air leaking out of your ducts, comfort and safety issues are also a concern for homeowners because leaky ducts pull unwanted air from basements and attics.

The duct system in an unconditioned attic or basement is part of your home’s thermal boundary. So it should not only be sealed, but insulated as well to energy code standards, which is R-6 in the basement and R-8 in the attic. According to the U.S. EPA, sealing and insulating your ducts can increase the efficiency of your heating and cooling system by 20 percent to 30 percent. Comfort level can also be noticeably increased by maximizing air flow.

First, with the system turned on, check your ducts for air leaks at the seams where sections are connected; also look for obvious disconnections and holes. Where the duct boot connects to the floor should be sealed also. Any penetrations that go through the attic floor or through the floor to an unconditioned basement should be sealed with foam around the outside of the ducts.

Use only duct insulation that has foil and fiberglass on the inside. This will give you the best thermal boundary possible. Do not use foil-faced bubble-wrap. It will not provide an adequate R-value unless installed with an air-gap between the duct and the wrap, which is very hard to do.

If 100 percent of your ducts are inside the building thermal envelope (in heated and conditioned air space), then you are very lucky and you need only seal them without insulating them. You can have your ducts tested to see if they meet code as new home builders are required to do. Theatrical fog can be used to pinpoint duct leakage problems.

Text Only | Photo Reprints

Special Features
Port Pics
AP Video
Mint Gives JFK Coin a Face-lift Creative Makeovers for Ugly Cellphone Towers Ariz. Inmate Dies 2 Hours After Execution Began Crash Kills Teen Pilot Seeking World Record LeBron James Sends Apology Treat to Neighbors Raw: Funeral for Man Who Died in NYPD Custody Migrants Back in Honduras After US Deports Israeli American Reservist Torn Over Return Raw: ISS Cargo Ship Launches in Kazakhstan Six Indicted in StubHub Hacking Scheme Former NTSB Official: FAA Ban 'prudent' EPA Gets Hip With Kardashian Tweet Bodies of MH17 Victims Arrive in the Netherlands Biden Decries Voting Restrictions in NAACP Talk Broncos Owner Steps Down Due to Alzheimer's US, UN Push Shuttle Diplomacy in Mideast Trump: DC Hotel Will Be Among World's Best Plane Crashes in Taiwan, Dozens Feared Dead Republicans Hold a Hearing on IRS Lost Emails Raw: Mourners Gather As MH17 Bodies Transported